Painting the Valve Cover (Submitted by djoyner2080 on 02/16/03)

Brake Rotor Replacement (Submitted by Doug R. on 11/26/02)

Rear swaybar install (Submitted by Ryan C. on 10/29/02)

Custom AEM CAI (Submitted by Brian W. on 02/20/02)

Clear Corner How-to (Submitted by Anton E. on 12/08/01)

Adjustable Panhard Rod (Submitted by Kelly G. on 08/21/01)

Torsion Bar Install (Submitted by Ryan C. on 08/15/01)

Valve Adjustment (Submitted by Chris on 03/16/01)

Engine Break-In Period (Submitted by Chris on 03/09/01)

Brake Tips (Submitted by Chris on 03/09/01)

Header Installation (Submitted by Ryan C. on 03/07/01)

Custom Strut Bar installation (Submitted by Mike T. on 11/6/00)

Custom Cold-Air Intake installation (Submitted by Mike C. on 8/23/00)

Rear trim body panel removal (Submitted by Tom O. on 8/12/00)

• Remove the screws from the interior plastic trim at the rear of the hatch
• Remove five (5) 7mm ( I think that was the size) nuts that hold on the tail light assembly
• Once you remove the tail light assemblies, you can see four (4) 10mm nuts, two on each side of the 'Integra' sticker on the back of the car. You can also see one (1) 10mm bolt on the corner of the trim piece (near the edges of the car)
• Remove the four nuts and two bolts and the trim piece comes right off
• Installation is the reverse of removal